Kitchen Cabinets with Crown Molding

The angle crown and cove crown are both well suited to standard ceiling heights. The angle crown (1 3/4" deep by 1 3/4" tall) sits close to the cabinet top and reads clean without overwhelming a lower ceiling. The cove crown offers a softer, curved transition at a slightly larger scale. Either way, measure the full top run of your wall cabinets and add roughly 10 to 15 percent for miter waste before ordering.

The large angle crown (3" deep by 3" tall, in 96-inch lengths) is designed for kitchens with taller ceilings, typically 9 feet or higher, where a standard-height profile would look undersized at the top of the cabinet stack. It follows the same finish matching as the rest of the molding line, so the color stays consistent across the whole run.

Yes. Every crown profile, light rail, and accent molding in our catalog is offered in finishes coordinated to the cabinet collections we carry. That means the trim color continues the same painted or stained tone as the doors and boxes rather than being an approximate match. When you order, select the finish that corresponds to your cabinet line.

Cabinet crown is cut shorter and at shallower angles than ceiling crown, so the process is more manageable. A miter saw set to the correct spring angle handles the cuts. The molding ships as finished 96-inch lengths, and your installer or a confident DIYer cuts them to fit the run. How-to resources are available on the site, and our team is happy to walk you through the planning process if you call (352)462-3335.

Light rail mounts to the bottom edge of wall cabinets and provides a finished transition between the cabinet base and the countertop or backsplash zone below. It also conceals under-cabinet lighting hardware when that lighting is present. Both a standard and an angled light rail option are available, so you can choose the profile that complements your chosen crown style and door design.

Measure the total linear footage of wall cabinets that will receive trim along the top. Add the same measurement for any bottom-edge light rail runs. Because inside and outside corners both require angled cuts, build in at least 10 to 15 percent extra on each piece type. Molding is sold by the piece in 96-inch lengths, so divide your adjusted total by 8 feet to get your piece count, then round up.